Comment(by bernard_aboba@…):
Proposed Resolution:
In 2.2.1.2, s/same response. This is not useful since/same response,
since/
Replace Section 2.4.3 with the following:
A value of two for Altitude Type indicates that the Altitude value is
measured in floors. This value is relevant only in relation to a
building; the value is relative to the ground level of the building.
In this definition, numbering starts at ground level, which is floor
0 regardless of local convention. Floors located below ground level
could be represented by negative values. Larger values represent floors
that are above (higher in altitude) floors with lower values.
Non-integer values can be used to represent intermediate or sub-
floors, such as mezzanine levels. Example: a
mezzanine between floor 1 and floor 2 could be represented as a value
= 1.1. Example: (2) mezzanines between floor 4 and floor 5 could be
represented as values = 4.1 and 4.2 respectively.
--
---------------------------------------+------------------------------------
Reporter: bernard_aboba@… | Owner: bernard_aboba@…
Type: defect | Status: new
Priority: major | Milestone: draft-ietf-geopriv-3825bis
Component: rfc3825bis | Version: 1.0
Severity: Submitted WG Document | Keywords:
---------------------------------------+------------------------------------
Ticket URL: <http://trac.tools.ietf.org/wg/geopriv/trac/ticket/41#comment:2>
geopriv <http://tools.ietf.org/geopriv/>
_______________________________________________
Geopriv mailing list
Geopriv@ietf.org
https://www.ietf.org/mailman/listinfo/geopriv
